Arrival
We arrange collection, delivery, or an inspection out in the field.
For utilities, municipalities, and public works
Utility's Equipment
Repair backup for the pumping, airflow, power-transmission, and fleet equipment that water, wastewater, and public-service operations rely on to keep running.
Industrial gearbox work
The whole drive, rebuilt as one.
For pump stations, blowers, conveyors, service vehicles, and utility equipment, we rebuild the reducers, drives, shafts, bearings, and seals — and parts that are hard to source can be manufactured in-house.
What a repair may cover
An incoming inspection, full teardown and cleaning, measurements of every critical dimension, assessment of gears and shafts, fresh bearings and seals, restoration of housings and bores, newly manufactured gears where needed, careful reassembly, alignment, and a final round of testing.
Failures we see most
Chase the root cause, not just the broken piece.
- Leaking seals, and pumps losing prime
- Bearings running hot
- Wear on shafts and couplings
- Flow or pressure falling off
- Performance dropping off in vacuums and blowers
- Noise and vibration from gear drives
How a repair moves through the shop
Each gearbox, pump, or machine that arrives here follows the same careful route, from first inspection through to its return to duty.
Teardown
The whole assembly comes apart while the evidence of failure stays intact.
Inspection
Wear gets measured, the root cause gets pinned down, and everything is written up.
Quote
We set out the repair we recommend, along with any faster-turnaround options.
Repair
Components get machined, welded, rebuilt, or made from scratch.
Reassembly
Restored parts go back in alongside fresh bearings and seals.
Testing
Alignment, rotation, and running condition are all verified.
Return
Delivery is arranged and the equipment heads back to work.
Pump and vacuum work
Bring back the flow, the pressure, and the dependability.
Our benches cover sump and sewage pumps, diaphragm and metering pumps, boiler-feed units, split-case and end-suction designs, and gear, lobe, screw, cavity, and vacuum pump systems.
- Full teardown with a documented inspection
- Service for shafts, bearings, and seals
- Impellers, rotors, and housings restored
- Machining, plus help with parts no longer made
- Precise alignment and careful assembly
- Expedited turnaround whenever the schedule allows
Makes and configurations we handle
Our benches cover both older legacy units and current production equipment from a wide spread of industrial gearbox and pump makers. Ring us with the precise nameplate details, model, and symptoms, and we will confirm how the repair would run.
Gearbox, reducer, and drive makes
FalkDodgeFlenderNordSEW-EurodriveRossiSumitomoWinsmithBonfiglioli
Pump, blower, and vacuum makes
GouldsGorman-RuppFairbanks MorsePattersonPeerlessVikingTuthillGardner DenverWaukeshaBuschNashKinneySutorbiltDuroflowHibonElmo Rietschle
Configurations covered
On the gear side: parallel-shaft, right-angle, worm, helical, bevel, and planetary units, plus custom-built drives. On the fluid side: centrifugal, split-case, turbine, submersible, positive-displacement, diaphragm, metering, and slurry pumps, together with vacuum and blower systems. Send us a photo of the nameplate so we can pin down the exact model before any work starts.