Arrival
We arrange collection, delivery, or an inspection out in the field.
Serving mining, aggregate, and quarry operations
Mining Equipment
We repair and rebuild the gearboxes, pumps, hydraulics, and rotating equipment responsible for keeping material on the move in abrasive, high-load conditions.
Industrial gearbox work
The whole drive, rebuilt as one.
Conveyor drives, mill drives, reducers, and planetary units all get inspected and rebuilt here, along with their shafts, bearings, seals, and housings. Where a gear is worn out or no longer made, we can reverse-engineer it, re-cut it, or manufacture a replacement in-house.
What a repair may cover
An incoming inspection, full teardown and cleaning, measurements of every critical dimension, assessment of gears and shafts, fresh bearings and seals, restoration of housings and bores, newly manufactured gears where needed, careful reassembly, alignment, and a final round of testing.
Failures we see most
Chase the root cause, not just the broken piece.
- Worn and broken gear teeth
- Failed bearings and seals
- Wear in housings and on shafts
- Excess heat, noise, and vibration
- Abrasion from slurry, and cavitation damage
- Contamination, and lubrication that has failed
How a repair moves through the shop
Each gearbox, pump, or machine that arrives here follows the same careful route, from first inspection through to its return to duty.
Teardown
The whole assembly comes apart while the evidence of failure stays intact.
Inspection
Wear gets measured, the root cause gets pinned down, and everything is written up.
Quote
We set out the repair we recommend, along with any faster-turnaround options.
Repair
Components get machined, welded, rebuilt, or made from scratch.
Reassembly
Restored parts go back in alongside fresh bearings and seals.
Testing
Alignment, rotation, and running condition are all verified.
Return
Delivery is arranged and the equipment heads back to work.
Pump and vacuum work
Bring back the flow, the pressure, and the dependability.
Slurry pumps, dewatering pumps, and process pumps are torn down completely and inspected, with work carried out on shafts and bearings, seals replaced, impellers restored, and alignment and testing to finish.
- Full teardown with a documented inspection
- Service for shafts, bearings, and seals
- Impellers, rotors, and housings restored
- Machining, plus help with parts no longer made
- Precise alignment and careful assembly
- Expedited turnaround whenever the schedule allows
Makes and configurations we handle
Our benches cover both older legacy units and current production equipment from a wide spread of industrial gearbox and pump makers. Ring us with the precise nameplate details, model, and symptoms, and we will confirm how the repair would run.
Gearbox, reducer, and drive makes
FalkFlenderDavid BrownDodgeHansenHorsburgh & ScottLink-BeltLufkinNordPhiladelphia GearRossiSantasaloSEW-EurodriveSumitomoWinsmithBonfiglioliBrevini
Pump, blower, and vacuum makes
Schurco SlurryDragflowGouldsGorman-RuppFairbanks MorsePeerlessCornellWildenFlowserveNashKinney
Configurations covered
On the gear side: parallel-shaft, right-angle, worm, helical, bevel, and planetary units, plus custom-built drives. On the fluid side: centrifugal, split-case, turbine, submersible, positive-displacement, diaphragm, metering, and slurry pumps, together with vacuum and blower systems. Send us a photo of the nameplate so we can pin down the exact model before any work starts.